One of the widest ranges of steam traps in the market with standard to custom solutions providing the highest efficiency on your steam system.

Centrifugal and baffle separators remove moisture from steam and compressed air pipelines. Steam or compressed air and pass through the separator and, as a result of centrifugal forces, impacts and swirling effects are separated from the fluid or compressed air.

Automatic mechanical pumps specifically designed to remove and recover condensate. Self-contained units using steam or other pressurised gas as their motive power.

Sample coolers are specially designed to cool samples of boiler water or steam for analysis. These devices may be used for boiler water analysis and other sampling or cooling applications compatible.

Steam injectors designed for rapid heating of still or flowing mediums, inside basins and vessels. Steam enters through the inlet connection, passes along the center of the device and mixes with the cool medium, which is drawn in through radial holes.

Heat exchange solutions for steam and hot water application. Efficiently transfer and reuse heat energy from a primary heat source to a secondary fluid.

For recovering flash steam from condensate. The flash vessel allows the flash steam to separate from high pressure condensate.

The boiler blowdown expansion vessels are designed for handling the short bursts of intermittent blowdown from the steam boiler and other hot water drains. They allow the flash steam to separate and to vent safely to the atmosphere through the exhaust head.

The exhaust heads were designed to protect personnel from injury and exterior of buildings from harmful effects of steam ejection to atmosphere. The head is fitted at the end of a vertical exhaust pipe and effectively retains the moisture separated from the steam for draining.

The Hot condensate coolers is a cooling device that allows the mixing of hot condensate with a lower temperature condensate, avoiding hammering. Condensate discharge from higher pressure lines (drip points, for instance) is often connected to low-pressure condensate lines, with lower temperatures.

The condensate lifting pots particularly used in condensate lines where condensate must be transported without causing water hammers and noise and lifted to elevated condensate mains.

Fabricated packages refer to pre-assembled, custom-built valve systems that combine multiple components—such as valves, actuators, sensors, piping, and control accessories—into a ready-to-install skid or unit.

Designed to allow the placement of supply valves in a single location, reducing costs and providing an easy control of different lines.